Call me back | My basket | Checkout | Add to email list

     You are here: Website » Knowledge base

« back to website

Test / InternalDataChannels

Internal data channels (menu 7.2.5)

Scroll through the values from the built in sensors, where available.

ACCEL X
ACCEL Y
ACCEL Z
REF 1
REF 2
GPS
WHEEL SPEED
RPM LOW
RPM HIGH
ADC 1
ADC 2
ADC 3
ADC 4
ADC 5
ADC 6
ADC 7
ADC 8


  • Accelerometer data X,Y,Z
    RAW CAL OFF *
    123 0.67 0.12
    ACCEL X
This shows the raw, calibrated, and current calibration offset values for the X accelerometer The * shows if this value is actually being used. This would be repeated for the Y and Z accelerometers


  • Internal reference voltage levels REFERENCE 1 and 2'''
    RAW CAL ON
    123 4.95
    REFERENCE 1
The RAW and CAL are the raw and calculated values from reading the output of the reference on the feedback. ON shows that the output is currently on. If the output is off then it will show OFF and the readings from the RAW and CAL values will show what is being read back from the pin as both a raw ADC reading and as a processed voltage.


  • GPS
    VEL POS ALT
    1.3 3.4 1.7
    GPS
VEL is the velocity accuracy, POS is the positional accuracy, ALT is the altitude accuracy, This is intended to show that the GPS unit is doing something and see what the accuracy figures are.


  • WHEEL SPEED
    RAW CAL *
    123 4.95
    WHEEL SPEED
RAW is the raw frequency values read from the wheel speed input, CAL is the calibrated value after units conversion


  • RPM
    RAW CAL *
    123 3.4
    RPM LOW/HIGH
RAW is the raw frequency values read from the RPM input, CAL is the calibrated value after units conversion


  • ADC channels
This is to show the raw and processed values from the internal ADC channels
RAW CAL
123 3.4
ADC 1
RAW is the raw reading from the ADC on the processor, CAL is the calibrated reading from the ADC
Page last modified on November 01, 2013, at 06:25 AM