Installing the IMU06
Connecting to RT Products
Connecting to a CAN system
The IMU06 will require power and signal wires connecting to the 9 way d-type connector for operation. The required wiring is:
| Pin 5
| Gnd
|
| Pin 7
| +12v
|
| Pin 6
| CAN L
|
| Pin 8
| CAN H
|
Note: There is no termination resistor inside the IMU06. If one is not present on the system then a 120 ohm resistor should be attached across pins 6 and 8.
Connecting to other data logging systems
The IMU06 can be connected to a variety of data logging systems, using either the RS232 or the CAN interface. A timepulse output is also provided for data alignment purposes. The connections to the IMU06 are as follows:
| Pin 2
| RS232 TX
|
| Pin 3
| RS232 RX
|
| Pin 5
| Gnd
|
| Pin 6
| CAN L
|
| Pin 7
| +12v
|
| Pin 8
| CAN H
|
| Pin 9
| Timepulse output
|
Note: There is no termination resistor inside the IMU06. If one is not present on the system then a 120 ohm resistor should be attached across pins 6 and 8.
My basket |
Checkout |
Add to email list
Edit
History
Print
Download (.HTML)
PDF