Logging data using the DL1 CLUB
Powering up the DL1 CLUB
Start the vehicle, wait a few seconds the "Power" LED will come on. Wait for a few moments while the GPS receiver acquires a good positional lock. Once the GPS has a lock, the GPS LED on the front of the DL1 CLUB will light up.
Insert an SD card
Take an SD or SDHC card and format it in the PC – the card must be formatted as “FAT32” formatting it as “NTFS” or any other file system will cause unexpected behaviour. When formatting is complete, remove the card and place it in the DL1 CLUB slot. Once it is inserted wait a few seconds and the status light should start flashing indicating that the DL1 CLUB is ready to start logging data. If the status light does not start flashing, power down the DL1 CLUB and repeat the above steps. If the status light does not flash on / off in equal measure then it could be one of the following problems:
- SD Card detection error - one quick flash and off period
- FAT file system initialize error – two quick flash and off period
- SD card write error – three quick flash and off period
- SD card read error – four quick flash and off period
Sampling data
To sample some data, simply press the "Start/stop logging” button on the front of the DL1 CLUB. After a short pause, the "Logging" LED will illuminate, indicating that data is being stored on the memory card. Drive the vehicle around for a while (slowly, safely and in a responsible manner). To stop sampling press the "Start/stop logging" button again. When you have stopped sampling data you can turn off power to the DL1 CLUB unit. Never remove the card from the DL1 CLUB whilst it is logging data. This can corrupt the card and the data will be lost.