Hi All
I have recently bought a DL1 Pro and I'm working my way through the software. I would like to attend the course Race Tech were offering, but it doesn't seem to be running at the moment..Any news on that?
Anyway, I am struggling to read live data through the monitor program, of a linear potentiometer. I have set it up on ADC1, metered it out and I'm getting 0-5v. Am I missing something obvious in the software?
Thanks in advance
Andrew
Newbie Question...Reading analogue input live
Good afternoon,
We aren't running the course at the moment as we are having some building work done at the office - hopefully this will be completed soon so we can get back to "normal". Sorry about the delay on this, we had hoped it would all be sorted out by now!
With regards monitoring the output, are you seeing anything from the DL1 at all at the moment? You should see this from the DL1's serial port. Note that with the current firmware the live data isn't available on USB, although this will be changed in the next firmware build available in the next few weeks.
Kind regards,
Support - Andy
We aren't running the course at the moment as we are having some building work done at the office - hopefully this will be completed soon so we can get back to "normal". Sorry about the delay on this, we had hoped it would all be sorted out by now!
With regards monitoring the output, are you seeing anything from the DL1 at all at the moment? You should see this from the DL1's serial port. Note that with the current firmware the live data isn't available on USB, although this will be changed in the next firmware build available in the next few weeks.
Kind regards,
Support - Andy
Return to “General software support”
Who is online
Users browsing this forum: No registered users and 4 guests