I'd like to hard wire the Dash2 serial data lines from a Dash2 to the connector block on the DL1.
Tx on the Dash2 goes to the SRx on the DL1?
"Standard" RS232 protocol requires a ground line as well. I need one to have the DL1 and Dash2 talk properly?
Dash2 > DL1 Serial hard wire
Dash2 > DL1 Serial hard wire
BMW 2000 M Coupe
Hi,
You need Tx, Tx and Ground for the data connection, note that data goes in both directions between the DL1 and the DASH2. So you need:
DL1 side DASH2
Tx ---------------------------> Rx
Rx ---------------------------> Tx
Gnd -------------------------> Gnd
The pinouts are included in the knowledge base for all products.
Kind regards,
Support
You need Tx, Tx and Ground for the data connection, note that data goes in both directions between the DL1 and the DASH2. So you need:
DL1 side DASH2
Tx ---------------------------> Rx
Rx ---------------------------> Tx
Gnd -------------------------> Gnd
The pinouts are included in the knowledge base for all products.
Kind regards,
Support
Return to “Installation questions”
Who is online
Users browsing this forum: No registered users and 17 guests