Wheel Speed Dash 2
-
- Posts: 20
- Joined: Tue Dec 16, 2008 12:28 pm
- Location: Darlington
Wheel Speed Dash 2
I have fitted a Telemechanique 3 wire inductive prox to my front wheel sensing off the 4 brake disc bolt heads, the sensor iluminates when the bolt head passes the sensor so im confident the sensor is set up correctly, but no Dash-2 speedo reading when I spin the wheel, any thoughts?
Polygon motorsport
for all your 7 needs
for all your 7 needs
I just struggled through this with my DL1.
After I re-read the spec sheet on the unit, I discovered that it requires a minimum 5vdc signal from the wheel speed sensor. For whatever reason the Cherry GS1001 sensors do not, but the Cherry GS1005 sensor do supply that when powered. I just happen to use Cherry sensors at work....
I also found that using car (unregulated) voltage resulted in speed reading errors (Looked like sensor saturation spikes), but when I used a 10vdc linear voltage regulator to power them, I get a very nice, clean, signal.
After I re-read the spec sheet on the unit, I discovered that it requires a minimum 5vdc signal from the wheel speed sensor. For whatever reason the Cherry GS1001 sensors do not, but the Cherry GS1005 sensor do supply that when powered. I just happen to use Cherry sensors at work....
I also found that using car (unregulated) voltage resulted in speed reading errors (Looked like sensor saturation spikes), but when I used a 10vdc linear voltage regulator to power them, I get a very nice, clean, signal.
-
- Posts: 20
- Joined: Tue Dec 16, 2008 12:28 pm
- Location: Darlington
Return to “Sensor-related questions”
Who is online
Users browsing this forum: No registered users and 23 guests