I'm seeing some weirdness/inconsistency with auto start/stop configuration settings. Specifically, auto start seems to trigger sporadically (it starts when it's supposed to, but also at other times) and auto stop hasn't worked yet.
This is with firmware 8-5 and software 6.3.121.
Here's what I did:
- Formatted a CF card
- Did a configuration: Auto start based on speed (>350), auto stop based on speed (<10), pre-trigger time of 1 minute, post-trigger disabled. I also set the timestamp to GMT-5. Saved the setup.bin to the CF card.
- Started DL1, inserted card. The top green light went off for a couple of seconds and then back on.
- Formatted that CF card, then reinserted it into the DL1
Without even moving the car, logging started.
This is the run file that was generated. Of course there is some jumpiness to the line, but the maximum speed that I see is 2.9 mph (far below the auto start threshold). Is there some sort of user error that could be causing this?