Hello,
I bought one DL1 MK2 and one DASH2 some years ago both new from RT for a car project.
The DL1 has been used stand alone as logger and the DASH2 is installed in the now running car project.
The DASH2 is firmware updated to 10.0.06 (something) and is configurable from the newer computer software.
Now i would like to hook up the DASH2 and DL1 Mk2 to each other so i can start logging from the DASH2 buttons and se values from the DL1 in the DASH2 display.
I cant find any usefull information how to do this.
I also bought a ECU inteface for my OMEX 600 engine management box. If possible i vould like to have that in the chain also.
Kind Regards
Fredrik from Sweden.
Dash2 hooked up with DL1 MK2
Re: Dash2 hooked up with DL1 MK2
Hello Frederik
Please see below page for a diagram of how to connect your DL1, DASH2 and ECU Interface:
https://www.race-technology.com/wiki/in ... -ECU-DASHx
The page also has a link to some information regarding configuring the DL1 to work with the dash.
I hope this helps.
Support (AH)
Please see below page for a diagram of how to connect your DL1, DASH2 and ECU Interface:
https://www.race-technology.com/wiki/in ... -ECU-DASHx
The page also has a link to some information regarding configuring the DL1 to work with the dash.
I hope this helps.
Support (AH)
Return to “General software support”
Who is online
Users browsing this forum: No registered users and 14 guests