Hi All,
I load up a .run file and the Analysis tool loads it, automatically creates a lap marker and then a large number of sector markers. These are numbered something like M2, M2.1, M2.2, M3,... and there seem to be many. In addition, I do not see a reasonable number of sector columns
I would have expected to see a set of markers that apply to all laps and I can evaluate the laps easily.
What am I doing wrong?
Thanks
Ray
Problem with Lap and Sector markers
Re: Problem with Lap and Sector markers
Have you perhaps selected the option selected to automatically add lap and sector markers?
I'm trying to remember where exactly the option is, maybe under Analysis options...
I'm trying to remember where exactly the option is, maybe under Analysis options...
Re: Problem with Lap and Sector markers
Ok, If I deselect that, I should be able to manually enter what I want?
Re: Problem with Lap and Sector markers
I believe so, give it a try... pretty sure that's how mine's set, and I do all mine manually...
Return to “General software support”
Who is online
Users browsing this forum: No registered users and 44 guests