Hello, im trying to set up my oil/ water temp sensor and oil pressure sensor, i have wired everything up and used standard senors on the setup but im getting 137's 136's for the temps and -18.7 for oil pressure?
any ideas??
cheers
RT SENORS
-
- Posts: 220
- Joined: Thu Mar 15, 2007 3:41 pm
- Location: Norwich, UK
- Contact:
-
- Posts: 220
- Joined: Thu Mar 15, 2007 3:41 pm
- Location: Norwich, UK
- Contact:
What equation are you using? I don't really know the Dash2, I just use equations in Analysis, but I would assume there are presets in the Dash2 configuration.
If that is still giving funny values, have you tried using a manual equation? They are on the website or the help files if you don't have them.
If manual works whilst preset doesn't then you might need to update a file somewhere, and it becomes too complicated for me.
If that is still giving funny values, have you tried using a manual equation? They are on the website or the help files if you don't have them.
If manual works whilst preset doesn't then you might need to update a file somewhere, and it becomes too complicated for me.
Monoposto 2000 - Reynard 883 Toyota
i have used the DASH 2 software, it has an option for the standard sensors supplied by RT, im not sure what else to try! i have check all wiring used other dash 2 tried different sensors
temps are ranging from 136-137
oil pressure at -18.7 ish
i think this might be the default reading for when the sensor is unplugged?
i have the three red wires going to the 5V ref wire, ( getting 5v's now )
earthed all black wires
signal wires going to A inputs on the dash two ( green/yellow blue and pink i think)
on the dash 2 software when selecting the inputs do i use the dash 2 analog inputs or normall analog?
thanks
temps are ranging from 136-137
oil pressure at -18.7 ish
i think this might be the default reading for when the sensor is unplugged?
i have the three red wires going to the 5V ref wire, ( getting 5v's now )
earthed all black wires
signal wires going to A inputs on the dash two ( green/yellow blue and pink i think)
on the dash 2 software when selecting the inputs do i use the dash 2 analog inputs or normall analog?
thanks
Hi Raba,
Are you using a DL1 or just the Dash 2 if Dash 2 only I think you have to use the Dash2 analogue channels
http://www.race-technology.com/wiki/ind ... ogueInputs
Regards
Simon
Are you using a DL1 or just the Dash 2 if Dash 2 only I think you have to use the Dash2 analogue channels
http://www.race-technology.com/wiki/ind ... ogueInputs
Regards
Simon
-
- Posts: 5
- Joined: Tue Jan 01, 2013 4:49 pm
-
- Posts: 5
- Joined: Tue Jan 01, 2013 4:49 pm
Return to “Sensor-related questions”
Who is online
Users browsing this forum: No registered users and 1 guest