I'd like to know if there is anyway of setting zeroes in the front and rear susp. I use a pot and I need to know how do I say to the analysis software where is the "zero"
Can somebody help me?
Thank you very much
Set zeroes on bike's pot
Set zeroes on bike's pot
Hi everybody!
I'd like to know if there is anyway of setting zeroes in the front and rear susp. I use a pot and I need to know how do I say to the analysis software where is the "zero"
Can somebody help me?
Thank you very much
I'd like to know if there is anyway of setting zeroes in the front and rear susp. I use a pot and I need to know how do I say to the analysis software where is the "zero"
Can somebody help me?
Thank you very much
Return to “General software support”
Who is online
Users browsing this forum: No registered users and 6 guests
