CANBUS Gear display on Dash 4

Bmsport
Posts: 3
Joined: Sat Dec 12, 2020 10:26 am

CANBUS Gear display on Dash 4

Postby Bmsport » Mon Jan 04, 2021 5:00 pm

I have an original/early Dash 4 Pro and the last of the Video 4 system with GPS and a serial connector to read the CAN from my MBE ECU. Can I display the current gear from the CAN on my Dash 4. I can only find a possible calculated gear, for this I need all the gear ratios and tyre circumfurences or run an analog signal, but no option for CAN?

Support
Posts: 399
Joined: Mon Nov 21, 2005 4:09 pm

Re: CANBUS Gear display on Dash 4

Postby Support » Tue Jan 05, 2021 3:08 pm

Hi - Which model of MBE ECU are you using the Race Technology equipment with?

Thanks
______________________________
Posted by Race Technology Support

Bmsport
Posts: 3
Joined: Sat Dec 12, 2020 10:26 am

Re: CANBUS Gear display on Dash 4

Postby Bmsport » Wed Jan 06, 2021 1:10 pm

Its an MBE 9A9ECU which uses the same CAN system as the 9A4 and 9A8.

Support
Posts: 399
Joined: Mon Nov 21, 2005 4:09 pm

Re: CANBUS Gear display on Dash 4

Postby Support » Thu Jan 07, 2021 9:53 am

Thanks for the confirmation, we have not connected to a 9A9 yet but if it uses the same CAN protocol as the 9A4 & 9A8 ECUs it should communicate with our products. Unfortunately gear position is not listed as available from CAN - https://www.race-technology.com/wiki/in ... dMBE992CAN

However you will be able to calculate the current gear, based on the RPM and speed signal that the dash is receiving. Enter the gear ratios, final drive and rolling circumference of the wheel.
______________________________
Posted by Race Technology Support

Bmsport
Posts: 3
Joined: Sat Dec 12, 2020 10:26 am

Re: CANBUS Gear display on Dash 4

Postby Bmsport » Thu Jan 07, 2021 2:13 pm

Thank you for your reply, I can get a gear output from MBE on the CAN bus, but on my Video 4 and my Dash 4 Pro the gear indicator only allows for a serial input from the gear position sensor or from the gear ratio, diff ratio, speed calculation. No option for CAN?


Return to “General software support”

Who is online

Users browsing this forum: No registered users and 16 guests