Dash3 Manual:
<Load variable information>
<This allows you to load a new set of variable list from a VAR file to variable tree.>
How do I load a new variable list with the Dash3 configuration software?
The menu is missing the option as indicated in the help.
Where does the Dash3 configuration software get a list of variables?
Hustler
Variable list not loadable
Variable list not loadable
DL1-MK3+20HzGPS, DASH3
Re: Variable list not loadable
Spitballing here, but are you using v10 analysis software? I recently learned that v8.5 should be used with older devices since the v10 software pulls the variable list directly from the data file. I don't know if that also applies to the DASH-3.
Actually, I may have mis-stated this. From this link: viewtopic.php?f=8&t=4082
Actually, I may have mis-stated this. From this link: viewtopic.php?f=8&t=4082
...on the older DL1 MK2 it was a "pain" as the sensor in volts->units conversion was done on the PC, so you had to keeping loading in different variable files...On later DL1s (MK3 onwards, sold from about 2008) the conversion from volts->units is done on the actual hardware, so the PC software doesn't typically need to "know" about the different configurations. This makes the situation much simpler.
Return to “General software support”
Who is online
Users browsing this forum: No registered users and 3 guests