DL1 Club and DASH4 not reading ECU data properly

bltamil1
Posts: 6
Joined: Fri Sep 08, 2017 10:47 am

DL1 Club and DASH4 not reading ECU data properly

Postby bltamil1 » Sat Mar 13, 2021 11:01 am

Hi,

I am having some trouble with my DL1 Club and DASH4 setup, which doesn't seem to be connecting to the car ECU properly.

When I start the car (or switch the ignition on) it takes an age for the DL1 to connect to the ECU (the lights on the OBD2 adaptor don't come on for between 30-60 seconds). When the lights come on, the DASH4 displays the RPM, but not the Water Temp. Then the water temp does start counting up but only goes up to 4 and then cycles back to 0, and repeats.

It used to work fine, and I don't remember changing anything in the config file, any ideas on what might be causing this?

I have an external oil pressure sensor connected to the DL1 which works fine, and I've checked that the car's OBD2 port is sending data correctly, so it must be something in the Race Tech hardware or the config files.

Alex

racetec
Site Admin
Posts: 302
Joined: Thu Oct 27, 2005 12:02 pm

Re: DL1 Club and DASH4 not reading ECU data properly

Postby racetec » Mon Mar 15, 2021 9:28 am

Hi Alex

A member of our support team will respond to your email as soon as they can.

Best regards,
AH


Return to “Installation problems”

Who is online

Users browsing this forum: No registered users and 8 guests