Sensor dimensions

disquek
Posts: 150
Joined: Thu Dec 08, 2005 9:13 pm

Sensor dimensions

Postby disquek » Fri Dec 16, 2005 7:39 pm

I'm getting ready to install water temp and oil pressure sensors.

Can you tell me the thread type and pitch on the oil pressure sensor and the depth that the water temp sensor will stick into a manifold? Ideally I'd like the depth that the furthest tip of the sensor is from the surface of the manifold.

Thank you!
-Kyle Disque

disquek
Posts: 150
Joined: Thu Dec 08, 2005 9:13 pm

Postby disquek » Thu Dec 22, 2005 3:49 pm

Bump ...

I didn't think this was a tough question.

-Kyle

Support

Postby Support » Sat Dec 24, 2005 9:33 am

This is the spec of the pressure sensor:

Fuel/Oil pressure sensor
High quality stainless steel bodied pressure sensor.

-Operating temperature of -40


Return to “Sensor-related questions”

Who is online

Users browsing this forum: No registered users and 27 guests