And here's the chart showing the calculated values and those measured (using a footpump and spare gauge!)
VDO oil pressure sender with DL1/Dash2
VDO pressure sensor calibration files
Hi
Can anyone please send VDO pressure sensor and Temp sensor calibration files they may have to suit Dash 2
mark@ballaratbolts.com.au
most appreciated
Cheers
Mark
Can anyone please send VDO pressure sensor and Temp sensor calibration files they may have to suit Dash 2
mark@ballaratbolts.com.au
most appreciated
Cheers
Mark
-
- Posts: 20
- Joined: Tue Dec 16, 2008 12:28 pm
- Location: Darlington
Support wrote:Hi Everyone,
I'm getting quite a few support questions relating to connecting the VDO sensors to our products... so I'm going to put up a wiki page o the site about them and how to set them up. If there is any calibration information available then please forward it to me at andrew at race-technology dot com and I'll make sure that it gets included!
Kind regards,
Andy
Come on Andy stick a link on then
I would like tables for 5 bar oil std water temp and fuel sender
Polygon motorsport
for all your 7 needs
for all your 7 needs
VDO has a few technical support documents that include resistance charts for the instrumentation that they manufacture. You can find it here.
http://usa.vdo.com/products_solutions/c ... uments.htm
http://usa.vdo.com/products_solutions/c ... uments.htm
Return to “Sensor-related questions”
Who is online
Users browsing this forum: No registered users and 13 guests