Configuring brake pressure sensor
Posted: Sat May 01, 2021 8:28 pm
by Chris
I'm currently working through the DL1 Club config and have the RT supplied brake pressure sensor wired into An4 but I'm unsure what to select in the software. I can't find a brake pressure option?
Re: Configuring brake pressure sensor
Posted: Wed May 05, 2021 12:37 pm
by Support
Hello Chris,
If you map your input to a pressure channel you will then be presented with a choice of RT-supplied pressure sensors to choose from. In your case select the Bosch brake pressure sensor.
The principle is described here:
https://www.race-technology.com/wiki/in ... ogueInputs
This shows temperature but the method is the same for pressure channels.
Regards,
Lorne Winborn