Oil Pressure Readout
Posted: Wed Oct 12, 2016 4:51 pm
Following on from a successful resolution to the fuel sender problem I hope this is the final problem to resolve
I'm running a CAN connection from a DTA S40 to the Dash 2 where rpm, speed, air and engine temp display correctly.
I have the oil pressure displayed but it counts up to around 650 then resets and starts counting again at engine idle speed.
In the DTA map I have the following settings.
VDO10 bar sensor selected; Filter value set at 5;
Both 40 psi and approximately 720 - 750mV are correctly displayed in real time at idle.
The Dash 2 settings are:
Scaling y=x; filtering 0.5; No. of samples 100; Native inputs mBar; Decimal places 2
I have set the DTA to display in bar to coincide with the Dash 2 but this gives the same result - count to 650 then reset to zero and start again.
Any suggestions will be greatly welcomed.
Thanks
I'm running a CAN connection from a DTA S40 to the Dash 2 where rpm, speed, air and engine temp display correctly.
I have the oil pressure displayed but it counts up to around 650 then resets and starts counting again at engine idle speed.
In the DTA map I have the following settings.
VDO10 bar sensor selected; Filter value set at 5;
Both 40 psi and approximately 720 - 750mV are correctly displayed in real time at idle.
The Dash 2 settings are:
Scaling y=x; filtering 0.5; No. of samples 100; Native inputs mBar; Decimal places 2
I have set the DTA to display in bar to coincide with the Dash 2 but this gives the same result - count to 650 then reset to zero and start again.
Any suggestions will be greatly welcomed.
Thanks