Hi,
First , Happy newyear and a succesfull 2014.
Does anybody know how to connect a Diesel commonrail pressure sensor to a DL1?
It have 3 pole connector wich I think should be;
Earth
Signal
12volt
I have tryd to find a wiring schematic but failed to find it
It should have 0.5volt @12.5kPa and 4.5volt @115kPa
Regards,
Klaas
http://www.dieselinjectorsuk.co.uk/fuel-pressure-sensors-2/
Peugeot commonrail pressure sensor
Hi,
Yes ,I have tryed that and also found a wiring diagram but I can not get it to work.
In the diagram pin 2 is described as "signal" as you sayd.
no further strange things in wiring from sensor to ECU.
Already bought a 2nd new sensor but can't get it to work either so it's probably a wiring problem.
I try'd a 5volt pullup? voltage to pin 2 , however when I measure that I have no moving voltage either when I vary pressure.
I would use only the sensor and I have not a car in wich it belong.
Strange as it looks a very easy sensor to use
Yes ,I have tryed that and also found a wiring diagram but I can not get it to work.
In the diagram pin 2 is described as "signal" as you sayd.
no further strange things in wiring from sensor to ECU.
Already bought a 2nd new sensor but can't get it to work either so it's probably a wiring problem.
I try'd a 5volt pullup? voltage to pin 2 , however when I measure that I have no moving voltage either when I vary pressure.
I would use only the sensor and I have not a car in wich it belong.
Strange as it looks a very easy sensor to use
Return to “Sensor-related questions”
Who is online
Users browsing this forum: No registered users and 37 guests