Hi,
I'm really questioning the output of these senders.
Does anyone else have both F&R senders and care to exchange data?
-Kyle
Anyone with F&R brake press senders want to exchange dat
IIRC, the M3 pedal ratio is in the 4.2 range with OE booster.
MC size is 25mm and the front piston is 60mm dia and the rear piston is 40mm dia.
You should be able to do the basic math to figure out how much pressure you should see in the system based on the pedal ratios and MC size. You should be in the 1,000psi range for a dual master setup when you push with ~200lb of force on the pedal.
Have you checked the formula in the analysis package?
MC size is 25mm and the front piston is 60mm dia and the rear piston is 40mm dia.
You should be able to do the basic math to figure out how much pressure you should see in the system based on the pedal ratios and MC size. You should be in the 1,000psi range for a dual master setup when you push with ~200lb of force on the pedal.
Have you checked the formula in the analysis package?
BMW 2000 M Coupe
if ur questioning the reliablity of the sensor, use a pressure gauge to verify
http://www.amazon.com/Liquid-Filled-Pre ... B001N2CZZC
i try to make custom equations, i know it takes a lot of the fun out of it...
http://www.amazon.com/Liquid-Filled-Pre ... B001N2CZZC
i try to make custom equations, i know it takes a lot of the fun out of it...
Return to “Sensor-related questions”
Who is online
Users browsing this forum: No registered users and 14 guests