I have the DL1 linked to Dash2. Channel 1 is dedicated to Water Temp. It comes on at a reasonable level, but then gradually creeps higher (without the engine running). In about five minutes it's gone from 5 degrees to 30 degrees, and in half an hour maybe 150 degrees.
The sensor is a standard Caterham water temp sensor, with a 255 ohm pull up resistor to the 12V output of the DL1.
I can't quite figure out what would cause it to creep up in this manner. Other sensors (including oil temp) seem OK Any suggestions for what to check?
Temperature creeps up on its own
-
- Posts: 133
- Joined: Mon Mar 26, 2007 8:22 pm
Return to “Sensor-related questions”
Who is online
Users browsing this forum: No registered users and 11 guests