I am installing a DL1 and would like to use the VDO temp sensors with a pull down to the DL1 - the trick is I'd also like to use the same sensor to run the VDO Temp gauge.
Wondering if there are any issues with tapping off the sensor wire to the gauge for the pull downs to the DL1?
VDO temp Gauge/sensor + Pull Down to DL1
BTW, I found a nice calculator for pull-up/down resistor networks.:
http://www.electronics2000.co.uk/calc/calcdiv.php
http://www.electronics2000.co.uk/calc/calcdiv.php
Return to “Sensor-related questions”
Who is online
Users browsing this forum: No registered users and 12 guests