Problem interfacing Omex600, DL1 and D2
Posted: Fri Aug 06, 2021 7:11 pm
Last year I purchased 1x DL1 Club and 1x D2 to interface with my Omex 600 ECU.
I'm using the supplied loom between the D2, DL1 and ECU but I'm not able to get any communication whatsoever.
I'm attempting to use the following ECU channels:
-Throttle Position
-Air Temp
-Water Temp
- Lambda1
Wired into the analogue inputs on the DL1 I have:
-Analogue1 - Fuel
-Analogue2 - Oil Temp (RT sensor)
-Analogue3 - Oil Pressure (RT sensor)
-Analogue4 - Brake Pressure (RT sensor)
-Analogue5 - Steering Angle (RT sensor)
-Analogue6 - AFR (AEM gauge with output table specified)
-rL - Direct from ECU
I've attempted to setup the DL1 and Dash2 and there are no combinations I have tried which display any useful information whatsoever. (including using the live monitor apart from Oil Pressure). I'm unable to get any ECU data to either the Dash or DL1. I've got the manuals printed off which haven't managed to help me yet and I'm not finding the software very intuitive whatsoever.
I have the following queries:
When selecting ECU input on DL1 for Plug1 it gives a warning that with this configuration it can't be used with a Dash display. RS-2 is labelled as Dash2 on the wiring loom. How should this be wired?
Is there anyone close to Oxford who might be able to help me out please? Cash and/or beers waiting
I'm using the supplied loom between the D2, DL1 and ECU but I'm not able to get any communication whatsoever.
I'm attempting to use the following ECU channels:
-Throttle Position
-Air Temp
-Water Temp
- Lambda1
Wired into the analogue inputs on the DL1 I have:
-Analogue1 - Fuel
-Analogue2 - Oil Temp (RT sensor)
-Analogue3 - Oil Pressure (RT sensor)
-Analogue4 - Brake Pressure (RT sensor)
-Analogue5 - Steering Angle (RT sensor)
-Analogue6 - AFR (AEM gauge with output table specified)
-rL - Direct from ECU
I've attempted to setup the DL1 and Dash2 and there are no combinations I have tried which display any useful information whatsoever. (including using the live monitor apart from Oil Pressure). I'm unable to get any ECU data to either the Dash or DL1. I've got the manuals printed off which haven't managed to help me yet and I'm not finding the software very intuitive whatsoever.
I have the following queries:
When selecting ECU input on DL1 for Plug1 it gives a warning that with this configuration it can't be used with a Dash display. RS-2 is labelled as Dash2 on the wiring loom. How should this be wired?
Is there anyone close to Oxford who might be able to help me out please? Cash and/or beers waiting