Emerald ecu connection

Oconnorracing
Posts: 5
Joined: Wed Jan 15, 2020 7:54 pm

Emerald ecu connection

Postby Oconnorracing » Fri Jan 24, 2020 8:33 pm

Hi all,

I have a dl1 club and recently bought a lead from race technology to connect to my emerald k6 ecu. I have just received the cables but there 3 connections as follows:

Rs232 one
Rs232 two
Can port interface

Reading the website and emerald site - I am not 100% which one I use to go into the comms port on my ecu.

Separately the length of the cables is very short and where my ecu is mounted it would mean I would need to either mount the data logger on the floor or on the transmission tunnel cover both are pretty exposed in a Westfield.

So final question can I extend the cable? Or do race technology provide a longer cable?

Sorry to ask what are probably noddy questions but just keen that I get it right rather than damage the data logger or more importantly my ecu.

Any help would be much appreciated
Thanks

Pete
Attachments
334567C4-278C-465A-9ADD-BB52011728DE.jpeg
334567C4-278C-465A-9ADD-BB52011728DE.jpeg (152.27 KiB) Viewed 27549 times
D87974DE-AA9B-46EC-8581-9330398A253E.jpeg
D87974DE-AA9B-46EC-8581-9330398A253E.jpeg (97.9 KiB) Viewed 27549 times

racetec
Site Admin
Posts: 326
Joined: Thu Oct 27, 2005 12:02 pm

Re: Emerald ecu connection

Postby racetec » Mon Jan 27, 2020 9:21 am

Hi Pete

Please see below knowledge base page regarding connections:
https://www.race-technology.com/wiki/in ... 3AndK6-CAN

If you have any further questions please email support at race-technology dot com.

Support (AH)

Oconnorracing
Posts: 5
Joined: Wed Jan 15, 2020 7:54 pm

Re: Emerald ecu connection

Postby Oconnorracing » Mon Jan 27, 2020 9:53 am

Ok thanks I have emailed yourselves at race tech


Return to “Installation questions”

Who is online

Users browsing this forum: No registered users and 31 guests