Page 1 of 1

GoPro Wiring for DL1

Posted: Fri Aug 16, 2013 12:14 pm
by tum53
Can I have the wiring diagram for the GoPro lead please. I already have a charging box for my GoPro and I would like to make a new lead to charge the Gopro, as well as using the DL1 to auto-start.

Thanks Andrew

GoPro

Posted: Fri Aug 16, 2013 12:55 pm
by Support
Hello,

Do you mean the connection numbers inside the GoPro connector?

http://www.race-technology.com/wiki/ind ... rfaceCable

What is the charging box you have? We are thinking about integrating this into the DL1.

Kind regards,
Support (K)

Posted: Fri Aug 16, 2013 2:48 pm
by tum53
Hi

Yes the connection numbers inside the GoPro. I usually short pin 12 to pin 1 (gnd) for remote start, but I didn't know if your lead was wired differently.

The remote start/stop and charging box is one I made. I use a 12v - 5v converter from a radio control model shop, with an isolation switch and a LED.

Regards Andrew

Support

Posted: Mon Aug 19, 2013 12:40 pm
by Support
Hello,

We use pin 12 and one of the ground pins. The DL1 output a pulse at the start of logging to switch it on and pulse at the end to switch it off.

Which GoPro do you have?

Are you able to charge and record at the same time?

Kind regards,
Support (K)

Posted: Mon Aug 26, 2013 8:21 pm
by tum53
I have GoPro Hero 2. Charging is possible whilst recording.

Regards Andrew

Posted: Sat Dec 13, 2014 5:37 pm
by Buckie
Any possibilty a contour roam would be supported in a while?

Or anyone tried it?

GoPro Wiring for DL1

Posted: Sun Mar 24, 2019 2:32 am
by EdwardNug
hi Athos, we need to produce release 101 for Linux, but I donґt have a Linux machine, can you make it from the github repo?