We have installed DL1PRO and DASH4PRO combo and can't get the RPM readings correct!
When we hit the rev limiter at 7200rpm it will only display ~3600rpm. From idle upp to 3600 it's correct, but then it won't go any higher.
We are logging the RPM signal from the ECU which gives 2 pulses/rev according to Dunnell, the engine builder.
Any ideas...
BR
Kristian
RPM shows too low
-
- Posts: 133
- Joined: Mon Mar 26, 2007 8:22 pm
Return to “Installation questions”
Who is online
Users browsing this forum: No registered users and 6 guests