Hi,
I believe I can take the RPM feed from the coil +ve side and run it into the low level input on the DL 1 ?
I am a novice at this sort of thing so does this sound correct ? I am guessing the other input on the DL1 would then need to be to an earth ?
Any pointers greatfully received.
Thanks
RPM Feed from Radical SR4 Kawasaki Carbs
When taking an RPM signal from the ignition system you need to take a feed from the negative side of the coil and connect that to the High Level RPM input or "rh" on the back of the DL1, this needs to be well grounded to produce a good rpm feed.
Please see this page of the Knowledge Base for further information:
http://www.race-technology.com/wiki/ind ... sionPickup
Please see this page of the Knowledge Base for further information:
http://www.race-technology.com/wiki/ind ... sionPickup
Return to “Installation questions”
Who is online
Users browsing this forum: No registered users and 94 guests