Quick question. I assume I connect my tacho driver from my ecu the DL1 via the rH (rpm high level)?
Do I also have to connect my tacho driver to the engine speed input on my dash2, or will it read the information from the DL1?
RPM input DL1 + Dash2
It will read from either side. Probably preferable to have it go to the DASH so that if for some reason you have the DL1 out of the car your DASH will still be functional. DL1 will read it from the DASH when it's connected via serial.
Jeremy Lucas
Fast Tech Limited - a Race Technology Dealer
Fast Tech Limited - a Race Technology Dealer
-
- Posts: 133
- Joined: Mon Mar 26, 2007 8:22 pm
Jimster wrote:will the DL1 be able to read all the anaolgue channels from the dash (da1-4) also?
yes
Jeremy Lucas
Fast Tech Limited - a Race Technology Dealer
Fast Tech Limited - a Race Technology Dealer
The four analogue channels from the DASH2 will show up in the Analysis software and monitor software as channels 17-20. So when you have a DL1 + DASH2 you have 1-8 (DL1) and 17-20 (DASH2).
To enable the DL1 to log the data you need enable the decoding of incoming serial data on the DL1 and enable logging of incoming serial data to the CF card.
Martin
To enable the DL1 to log the data you need enable the decoding of incoming serial data on the DL1 and enable logging of incoming serial data to the CF card.
Martin
Return to “Installation questions”
Who is online
Users browsing this forum: No registered users and 1 guest