I picked up the RT Start/Stop button recently and finally got around to wiring it up this weekend. I used the wiring instructions in the FAQ and when I power the DL1 up, the LED in the button comes on, but when I depress the button, nothing happens. If I manually start logging with the button on the DL1, and then depress the remote button, it does stop the logging, but will not start it.
Anyone have a similar issue? I have triple checked the wiring to ensure it is going in the correct ports on the connector, and am at a loss as to what is causing the issue.
Another Remote Start/Stop question
-
- Posts: 220
- Joined: Thu Mar 15, 2007 3:41 pm
- Location: Norwich, UK
- Contact:
I found out yesterday that the wiring diagrams on the packets and knowledge base for the start/stop switch were wrong. I have now updated them, please check here for the correct version:
http://www.race-technology.com/wiki/ind ... nectSwitch
Martin
http://www.race-technology.com/wiki/ind ... nectSwitch
Martin
I started swapping wires around and got it working. Now, I am assuming the colored wires are hooked up correctly to the button, I may have an isolated QC issue on my button:
Red: 5V+
Yellow: GND
Blue: Stat
Green: Trig
In other words, I had to swap green and blue from the new wiring instructions Martin linked.
-Drew
Red: 5V+
Yellow: GND
Blue: Stat
Green: Trig
In other words, I had to swap green and blue from the new wiring instructions Martin linked.
-Drew
Return to “Installation questions”
Who is online
Users browsing this forum: No registered users and 17 guests