DL1 Logger cant send configuration

[baboon8008]

Hi,

Ive just added a Oil Pressure sensor to my Link G4+ ECU which is connected to the DL1 on CAN Bus.

All other variables are working, but nothing for Oil Pressure. Its fine in the ECU and Link have confirmed everything is correct.

So I'm trying to setup 'CAN data input' in the configuration to see if I need to add it this way

When I add Oil Pressure and configure that channel and then try to Send Configuration I get the following warning:

"CAN port 1 channels configured but only licensed for 0"

This suggests its not enabled, but how do I enable it. Its the same for anything I add in there

It was sent back to RT a few months ago for a firmware upgrade.

Cheers

[Greg Amy]

Sounds like the unit is no longer licensed for CAN. I'd suggest contacting R-T support directly with your unit's serial number, they should have a record of that license that you purchased.