When I run the DL1 reflash utility, and it's asking me to choose a file, it will not accept any choice I make.
I just stays on that file selection screen.
Even hitting cancel has the same result.
The HEX file I downloaded is named DL1V6.HEX and begins with:
DL1 code with GSM not automatically enabled
:0C06000091EF0EF0D4EF0EF080EF0BF045
:100700000D284329205261636520546563686E6F2C
and ends with:
:10F1D000EECF39F084EC26F0182EFAD70D0E73EC32
:08F1E00026F03B2EF3D71200CC
:00000001FF
Help!
-Kyle
DL1 reflash - file select issue
After quite a bit of hassle, I finally got it to flash.
The reflash utility doesn't like my desktop. I managed to borrow a laptop and it worked from that machine.
It's worth noting that my desktop runs the monitor software without issue and its serial port has always worked with other applications.
-Kyle
The reflash utility doesn't like my desktop. I managed to borrow a laptop and it worked from that machine.
It's worth noting that my desktop runs the monitor software without issue and its serial port has always worked with other applications.
-Kyle
The laptop is newer than the desktop. Both are Dell. Both are box stock. The desktop is a 4150 (two years old or so).
It has always worked fine with other apps that use the serial port, such as: The reflash for my racing radios, the programming for my home theater remote, reflash Garmin GPS, etc. Also, it worked fine with you monitor software.
Please see my other more pressing issues with the Dash1 in the bug section.
-Kyle
It has always worked fine with other apps that use the serial port, such as: The reflash for my racing radios, the programming for my home theater remote, reflash Garmin GPS, etc. Also, it worked fine with you monitor software.
Please see my other more pressing issues with the Dash1 in the bug section.
-Kyle
Return to “General support questions”
Who is online
Users browsing this forum: No registered users and 18 guests