Page 1 of 1

DTA T2 ecu to Dash2 via CAN interface

Posted: Wed Mar 15, 2023 2:37 pm
by Westfield 20XE
Hi,

Can anyone advise on what ECU to select from the drop down box when selecting ECU interface from the Dash2 configuration software?

DTA T & S series are not listed it seems, even though my CAN interface is for the T2 ECU.

Cheers

Re: DTA T2 ecu to Dash2 via CAN interface

Posted: Thu Mar 16, 2023 9:29 am
by racetec
DTA S40 S60 S80

Not DTA S40 S60 S80 - serial

DTA S-series and T-series outputs are the same for the purpose of this endeavour.

Re: DTA T2 ecu to Dash2 via CAN interface

Posted: Thu Mar 16, 2023 10:23 am
by Westfield 20XE
That's great thanks, I'll take a look later and see how I get on.

Re: DTA T2 ecu to Dash2 via CAN interface

Posted: Thu Mar 16, 2023 1:45 pm
by Westfield 20XE
I've changed the ECU interface settings to DTA S40 S60 S80 and ticked the sensors I want to view/receive from ECU.

I've then gone to the LCD data option and selected the appropriate corresponding options and selected where/what screen I want them on.

Uploaded and sent configuration to my Dash2 which I can see has changed but unfortunately still no data being shown or received from the ECU.

I've gone into the DTA T2 software to confirm the CAN settings are as per Race Technology settings.

I've confirmed I have a 12v and ground and that it's installed correctly and that the high and low wires are correctly installed in pins 16 & 17.

Is there something daft I'm missing regarding the configuration?

Re: DTA T2 ecu to Dash2 via CAN interface

Posted: Thu Apr 20, 2023 7:35 pm
by Westfield 20XE
Help!!!!!!!

5 weeks later and I'm still no closer to enabling my ECU data to appear on the Dash2.

Has anyone else used the CAN interface with the DTA T2 ECU??

I've submitted a tech support request but that seems to be going nowhere??

I also noticed today that the display is showing 2 miles on the odometer and trip which is odd as it was 0 and the car hasn't turned a wheel apart from spinning a wheel by hand??

Any ideas??

Thanks

Re: DTA T2 ecu to Dash2 via CAN interface

Posted: Fri May 19, 2023 5:43 pm
by Westfield 20XE
Unfortunately this is still an on going issue having started the tech support request on Maech 14th.

The CAN interface was returned for inspection on 3rd May and I've yet to hear from anyone?

I've sent two emails and made a call but still no news about any progress or anything in fact.

This has left me somewhat disappointed so far as I was so enthusiastic about the Dash2 and company.

I would very much appreciate if anyone from Tech Support could reach out to me.

Thanks.