I have a Dash2 unit which was working OK using the OBD2 cable, but has suddenly developed powering up issues.
When you connect power, it illuminates a random selection of top LEDs before they fade to off and the current draw from then on is around 20mA.
• I’ve bypassed all the wiring and tested it powered directly onto the connector pins and the behaviour is the same, is there anything most likely to be wrong?
• Can you tell from the power draw if it’s a regulator issue or the microprocessor has failed?
• Are there instructions anywhere on opening the unit so I could do a basic visual check on the pcb for issues?
Thanks for any help.
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 4 guests