Page 1 of 1

Engine Run On

Posted: Tue Nov 16, 2021 9:04 am
by STW
Hi,

Since fitting my Dash2 I've started suffering engine run on switching the engine off with the key. Has anyone any advice or pointers on where I might have gone wrong in the wiring possibly? The engine is a Rover K series fitted into a Rover 100/Metro

Re: Engine Run On

Posted: Wed Nov 24, 2021 6:39 pm
by Tech Support (D)
It seems odd that an electronic device would cause such an issue, could you possibly disconnect the DASH2 and see if the running-on issue persists? Might have just been a coincidence that the issue occurred whilst fitting the dash, thanks.