Race Technology

Hi all

I have a question regarding a problem with the oil pressure on my Dash2Pro.

I have a Renault Clio 3RS and using the Dash2Pro with a Ecu Master EMU Black. Unfortunately it shows constantly a 5.0 oil pressure, also when the engine is warm. It does not change at all. As soon as you start the ignition it jumps from 0 to 5. Oil temperature and water temperature works fine.

Any idea what this behaviour could be? I've flashed the firmware, no change. Any other ideas?

Thanks a lot!

Where is the sensor data coming from - oil pressure sensor or ECU?

Is it definitely a sensor and not a switch?

It's an oil pressure sensor which is directly connected to the Dash2Pro.

I'd be checking the wiring and pull up resistor. It sounds as though it's reporting the 5V reference wire.