Race Technology

Been a long time DL1 Mk2 user and for last 4 years also a Dash 2
Had no real problems , most analogue inputs via DL1 , only fuel pressure on Dash 2 analogue input
But contemplating upgrading to a DL1 Sport and using V10 and not v8.5
However this will relegate all my RUN's from 2011 onwards , useless. Can V8.5 read DL1 Sport RUN files ?

Hello Arno,

Yes it can.

Regards,
Lorne Winborn

Thanks Lorne
My one racing service provider has one in stock.
I have sent an email to support/sales re a problem experienced on Saturday with my DL1 Mk2 - Dash 2 combo
After uneventful race 1 ( logger and Dash performing as it should) in race 2 , start of lap 2 ( just after start /finish line ) the low oil pressure alarm ( set as alarm 2 ) came on , I immediately coasted to a safe halt.
Afterwards , I analysed the log file . No low oil pressure indicated on graphs and max /min summary stats. Pressure graph line very similar to final lap, race 1 when slowing to coast after start/finish line -
I have not changed the Dash 2 config at all, alarm settings the same , voltage drop to below 2,4bar in last 15 meters before dead stop and engine cut - lowest OP indicated on summary stats 0.9bar only at switch off or

Could this be a faulty serial cable or connection on either logger or Dash 2 connection . No other issues with Dash and logger indicates no problem with sensor

One of our technical support specialists will study the information you sent and respond to your email.

Regards,
Lorne Winborn

Will be appreciated , Thanks