Page 1 of 1

dash 2 pro canbus set up to life ecu

Posted: Mon Dec 21, 2020 8:29 pm
by peteg
help needed im new to dash 2 and canbus
i have 15 channel licence
i believe the life is set correct as per rt instructions 120ohm resistor fitted
i have canbus emblem up on dash
but how do i configure to get data on the dash 2 pro
i have update firmware and selected 15 canbus channels from drop down messages .
what else do i need to do .
regards pete

Re: dash 2 pro canbus set up to life ecu

Posted: Tue Dec 22, 2020 3:35 pm
by Support
Hi Pete - We are already supporting this enquiry over email, I've replied today but please bear in mind Christmas is a very busy time for us.

Thanks

Re: dash 2 pro canbus set up to life ecu

Posted: Tue Dec 22, 2020 4:48 pm
by peteg
yes received email and now working thankyou

Re: dash 2 pro canbus set up to life ecu

Posted: Sun Feb 14, 2021 9:19 pm
by peteg
can the dash 2pro menu buttons be programmed via can bus please. and if so how .

Re: dash 2 pro canbus set up to life ecu

Posted: Mon Feb 15, 2021 5:48 pm
by Support
Only via USB connector and DASH2 PRO configuration utility, the Unit Control Inputs section is where you can change the settings.

Best regards

Re: dash 2 pro canbus set up to life ecu

Posted: Wed Feb 17, 2021 7:53 pm
by peteg
was hoping to use wireless buttons on my steering wheel via canbus to change screens . and add markers, but im quessing you can only use the inputs .