Got som DL1 mk2 devices to check up before using them. What software do i use to read pressent configuration from eatch DL1 ?
I need to check up what firmware ver. and check what logging start/stop parameters on eatch DL1.
In basic how do I enshure that the funktionality of eatch box are working whitout having to installing eatch and every one in a car.
Using an 12V power supply, connecting GPS antenna and the RS232 cabel I was shure that the DeviceExplorer could help me out here, but found that is only Works on newer/bigger vertions of DL1.
How do you gues checkup your DL1-mk2 "on the table" ?
How to read pressent configuration DL1 mk2-
Support
Hello,
It is not possible to read back the configuration from the unit on the DL1 mk2. I recommend you leave the configuration on the memory card all the time to be sure it has the configuration on you want.
To check firmware please view the run manager from the analysis with a run file loaded in,
Kind regards,
Support (K)
It is not possible to read back the configuration from the unit on the DL1 mk2. I recommend you leave the configuration on the memory card all the time to be sure it has the configuration on you want.
To check firmware please view the run manager from the analysis with a run file loaded in,
Kind regards,
Support (K)
______________________________
Posted by Race Technology Support
Posted by Race Technology Support
Return to “General support questions”
Who is online
Users browsing this forum: No registered users and 28 guests