Hi gents,
I would like to ask the support team to look into the following document and ask a programmer to give some feedback too. MS3 and MS2 are with their newest firmware finally able to send CAN commands according to a standard protocol.
http://www.msextra.com/doc/general/file ... -03-10.pdf
This is great news. Can somebody tell me if your CAN adapter can be configured to run with it? should be possible, actually. But what needs to be setup?
regards, Thomas
Megasquirt MS3 again, CAN can work now!!
CAN .dbc File For Megasquirt MS3 and MS2
http://www.msextra.com/doc/pdf/Megasqui ... -10-27.dbc
Here above you find the .dbc file for MS2extra Firmware 3.4 and newer
and MS3 Firmware 1.4 and newer
Here above you find the .dbc file for MS2extra Firmware 3.4 and newer
and MS3 Firmware 1.4 and newer
Return to “General support questions”
Who is online
Users browsing this forum: No registered users and 21 guests