Dl1 + ecu cable. Missing data from ecu.

zlobo
Posts: 8
Joined: Thu Dec 06, 2012 7:12 pm
Location: sweden
Contact:

Dl1 + ecu cable. Missing data from ecu.

Postby zlobo » Thu Aug 29, 2013 9:05 pm

Hello,

I got a dl1 with serial cable connected to the ecu and i am missing data.
The thing i that it worked before and now it dont work.

any idea what it can be? or how i can trubleshoot this issue?

thanks.

Support

Postby Support » Fri Aug 30, 2013 8:50 am

I know it sounds really obvious, but have any configuration changes been made since it was last working, either to the ECU or to the data logger?

Martin

zlobo
Posts: 8
Joined: Thu Dec 06, 2012 7:12 pm
Location: sweden
Contact:

Postby zlobo » Fri Aug 30, 2013 9:38 pm

no, i only did some config changes after i noticed that i got no data from the ecu.

i dont know if its fw related i got a new fw in the begining of the year i think that increased the samplerate of the cable i dont know if that might have any thing to do with it.

zlobo
Posts: 8
Joined: Thu Dec 06, 2012 7:12 pm
Location: sweden
Contact:

Postby zlobo » Wed Sep 18, 2013 1:11 pm

Is it ok to keep the config file for the dl1 on the compackt flash cart or can it interfear with the ecucable?

Support

Postby Support » Fri Sep 20, 2013 6:36 am

There is no problem keeping the configuration on the card, but there is no need to.

Martin

zlobo
Posts: 8
Joined: Thu Dec 06, 2012 7:12 pm
Location: sweden
Contact:

Postby zlobo » Fri Sep 20, 2013 10:02 pm

can it be the fw i got? can it be a bug in it?

Support

Postby Support » Mon Sep 23, 2013 10:02 am

Check which version of the firmware you are running, but I'm not aware of any issues.

Martin

zlobo
Posts: 8
Joined: Thu Dec 06, 2012 7:12 pm
Location: sweden
Contact:

Postby zlobo » Tue Sep 24, 2013 12:02 pm

Support wrote:Check which version of the firmware you are running, but I'm not aware of any issues.

Martin


how do I check the fw version in the cable? had an issue before the upgrade where the samle rate of the data from the ecu was les than 0,5Hz.
so I got a new firmware for the cable.

Support

Postby Support » Tue Sep 24, 2013 1:42 pm

Please email the firmware you used for the cable directly to me, mhill at race-technology dot com.
To check your data logger firmware you can look in the run manager in the Analysis software.

Martin


Return to “General support questions”

Who is online

Users browsing this forum: No registered users and 26 guests