Hi
I have a DASH2, DL1, + ECU interface set up. The DL1 captures the data from the ECU fine, and the DASH2 displays the ECU data fine.
What doesnt seem to work, is the DL1 capturing the DASH2 anolouge inputs. I have these connected to capture fuel level, water temp etc but in 'Analysis' it indicates that there is no data avaible. If I export the data set to Excel, there is basically a 0 value for each of the 4 channels (A17, A18, A19, A20).
Any thoughts?
Ta
Bill
DASH2 data not captured on DL1 ?
Return to “General support questions”
Who is online
Users browsing this forum: No registered users and 22 guests