dash 2 shift lights and data log error

[mebilloz]

Hi All

I have just run my DL1/Dash2 combo in anger for the first time. In reviewing the data I noticed that the max RPM in the data log was just under 7000rpm. Yet I was shifting when all the shift lights came on which should have been at 7600rpm. The Dash is feed the Rpm from the ECU on a dedicated line. I am also running a ECU serial connection to the DL1. Any thoughts on this. I need to re-visit the camera footage to see if I can make out where the RPM indicator is when the lights go off.
Other than that, it was brilliant.

Thanks
Bill

[osborni]

Make sure that the data variables for RPM scaling are consistent between the Dash2 and Analysis software.

Dash2 config tool:
RPM tab, under Pulses per rev

Analysis:
Data>Edit Default Vehicle Options>> RPM & Wheel Pickup > Ignition Pulses per Rev

The DL1 is a "dumb" recorder, but I don't have an ECU adapter for cannot comment.