1, can somebody please tell me how to configure the dam things!! I'm picking up rpm signal ok which is showing on the dash 2 but when rev'd nothing till 4k.! I'm set at 7000 rpm limit and I'm on 2 pulse engine. I have no issues inputting the data just ain't got a frigging idea
2, I've wired in my fuel sender on my celica gt4 via analog output 1 using 5v reference ect..(no other sensors used) then emptied my tank to measure the resistance empty.. Then measured every 5 litres till full.. When I generated the data and uploaded it, it displayed the data as 199.35??? I ran the car for 20mins and this figure never moved. Just to clarify, how do you input/change my cataloged resistance data? Ie resistance to volts?
Fuel and shift light questions
I just did the same thing last friday. Best is to put equation y=x into the dash 2 fuel gauge and then rear voltage every 5litres. then you have to put the values into table and it will generate the equation for you. works for me very well. i have calibrated it to show me litres not percentage of the fuel tank so that i know how much fuel is there exactly.
-
- Posts: 9
- Joined: Sun Jan 16, 2011 7:54 pm
- Location: Welwyn Garden City, Herts.
Walezy wrote:I just did the same thing last friday. Best is to put equation y=x into the dash 2 fuel gauge and then rear voltage every 5litres. then you have to put the values into table and it will generate the equation for you. works for me very well. i have calibrated it to show me litres not percentage of the fuel tank so that i know how much fuel is there exactly.
How did you change it to litres please?
Return to “General support questions”
Who is online
Users browsing this forum: No registered users and 277 guests