Hi-
Just installed a DL1mkII in my car. Hooked up all of the analog sensors, the ECU interface, and dash3, and everything checked out fine. Rolled the car out into the driveway to test the GPS, and I get nothing on the GPS lock LED. It comes on for a second when turning on the master switch, then goes dark. The status light flickers like normal. Power LED is on, logging can be toggled on/off from the dash3. Tried the latest firmware. Configuration is the defaults you get when clicking on the "dash" button in the config software. Have tried disconnecting the dash, no change. Anything else I should try? Heading to the track tomorrow, would really like to have lap timing working this weekend, not to mention useful logging. Thanks,
-Chris
Dark GPS Lock LED
-
- Posts: 65
- Joined: Fri Jul 06, 2007 10:26 pm
- Location: Saint Louis, Missouri, USA
evl wrote:I've waited up to about 20 minutes. No luck. I've also moved the car to the middle of a runway, so it should have a pretty good view of the sky. :/
Just in case, examine the GPS cable for pinches and tight bends. Kinks in that cable are a real no-no. Make sure the center pin of its plug is not bent.
--Dan in Saint Louis
Return to “General support questions”
Who is online
Users browsing this forum: No registered users and 52 guests