Hi All,
i am looking for some guidance on 2 items please.
My current setup is a Race Dash 4 Pro connected to a DL1 club with the ECU interface into an Emerald K6 ECU.
1. My dash reads one gear higher than the car is actually in - any ideas on this?
2. can you setup the dash 4 pro for speed events i.e. a hillclimb so you measure or manually set the course and then it gives you a delta against the specific track? a bit like manually setting the track
thanks
Pete
Dash 4 Pro & DL1 Club - Speed events and Gear indicator
-
- Posts: 5
- Joined: Wed Jan 15, 2020 7:54 pm
-
- Posts: 17
- Joined: Thu Jul 26, 2018 7:01 am
Re: Dash 4 Pro & DL1 Club - Speed events and Gear indicator
Hi Pete - If you could email me your DL1 CLUB & DASH4PRO configuration files, I will check the gear position settings for you. If you also send me a typical logged run from one of your hill climb / sprint sessions, I'll show you how to setup timing info. My address is daniel AT race - technology dot com.
Return to “General software support”
Who is online
Users browsing this forum: No registered users and 3 guests