How to send serial data to the DL2?

[hector]

The DL2 can transmit data correctly to the pc, but how to let it log the serial data transmitted from the pc? I tried series like "095, 001, 050, 050, 196", but it seems not work. Should I set something? Thanks

[Support]

The DL2 expects a Race Technology serial data format from any serial data source. If you can configure your serial data according to the information in the link below you should be able to do this.

http://www.race-technology.com/wiki/ind ... DataFormat

[hector]

Hi, thank you
I send the data according to that serial data format, but it not works. So what might be wrong?

[Support]

Is the serial port set up on the DL2 configured to receive data?
This is the tick box in the Serial Port tab in the DL2 configuration software, you need to remove the tick from the box and then set the baud rate to the correct setting.

[hector]

Got it, Thank you

[hector]

Hi Support,

Sorry to bother you again. I followed your instructions, but it still not works. For example, if I want to send to analog 17, I wrote "036, 042, 100, 178" every 0.1 second. What might be the reasons that caused this. Thank you

[Turby]

Could be lots of things... worth checking your RS232 wiring with a brake out box and also the configuration of the RS232 on your device (baud rate, data bits, parity, stop bits). Double check your DL2 configuration settings as well.

[Support]

You can try writing the data in to a file and then loading it in to the Lite Monitor to see if it is correct.
In the latest version of the lite monitor there is an option to show data which is transmitted from the file transmit feature so you can use that to test your messages.

You will need to download the latest Analysis software package (Build 7071)

[hector]

Hi Turby and Support,

Thank you, and I'm going to test that

[hector]

Hi,

I'm very sorry, the serial receive still not work...The
connection is correct and the baud rate is 115200, disable
the "decode serial data". And I save the output stream to a
file and the analysis software can work on it properly. But
just can send data to DAQ? Is there any other possible
reason? Do I need to update the hardware? Thanks

[SundayForever]

Hey guys, do it with your heart! Come on!