DL1 Wont read Oil Pressure

[baboon8008]

Hi,

Ive just added a Oil Pressure sensor to my Link G4+ ECU which is connected to the DL1 MK3 on CAN Bus.

ts fine in the ECU and Link have confirmed everything is correct at their end.

All other variables via CAN are working (coolant temp, IAT etc), but nothing for Oil Pressure.

I havent had to set anything specific up for these to work!

I'm trying to setup a 'CAN data input' in the configuration to see if I need to add it this way

When I add Oil Pressure and configure that channel and then try to Send Configuration I get the following warning:

"CAN port 1 channels configured but only licensed for 0"

This suggests CAN is not enabled, but how do I enable it. Its the same for anything I add in there

The unit was sent back to RT a few months ago for a firmware upgrade.

Cheers