I am using the Dash2 Pro and have the oil pressure sensor fitted. On the display it shows the pressure which seems right as it rises to about 2.9 bar when the engine is running. However I dont have a pressure warning light on the car so wanted to configure the warning to alert on low, and/or high, pressure.
As a test I configured the dash to show a warning if the oil pressure was below 1 bar - so I was expecting it to alert me when the ignition was on, but the engine stopped as the oil pressure would be 0 - this worked fine, however when I start the engine the display shows oil pressure over 2 bar but the warning lights are constantly flashing... which is obviously not right

The sensor is configured as Analogue Input 2 and is configured as;
Maximum rate of change = 0
Smoothing filter time (seconds) = 0
Calculus = Disabled
Input Equation = Fuel/Oil pressure sensor in Bar
Map Channel to = Oil Pressure {pressure 2} [Bar] (OIL P)
In the Alarms section I enabled Alarm 3 and set the variable to "Oil pressure {pressure 2} [Bar] (OIL P)", set unit to "Bar", condition to less than "<" and value to "1".
I expected this to bring the warning LEDs on if the pressure was below 1 bar... but it stays on all the time - can anyone help with what I am doing wrong?
Also, I would really like to change this to psi rather than bar... in the Analogue input configuration the input equation is set to standard (Fuel/Oil pressure sensor in Bar) - can I just change this to Y=14.5037738*x, or do I need to change this somewhere else?
Also, is there a way to display the current battery voltage, as I have had an issue with the alternator overcharging (16v+) and would like to have an easy way of monitoring this for future problems?
Many thanks for any pointers.