Actually, LC, you say "reflashed the firmware". Assuming you have not had a PC link via Serial cable and used the Reflash utility, you haven't "reflashed". The SETUP file simply instructs the existing... I did reflash the firmware using the serial cable and reflash utility. That...

Assume I've set up an Autostart condition (e.g., speed > 30 kph) in the setup.bin file and loaded that file into the DL1 properly. Now, when I use the DL1 normally, is the "Logging" light supposed to turn on a few seconds after I power up the DL1 or is the "Logging" light only su...

So I tried reflashing again (with the same firmaware as I tried last time). The firmware file was definitely unzipped. And I tried a default configuration. However, the problem still remains. The DL1 begins logging data a few seconds after it's powered on. And if I stop the logging by pressing the r...

Hi: Does it behave that way if you load a totally default config file? You might want to modify the filename of the .run file so that you can make sure that the DL1 is reading / applying the config file. I will try a completely default config file. Stay tuned. Then I'd try reflashing, I think. Sill...

Previously, my DL1 was working flawlessly. I had Autostart triggering at >50kph with a 2 minute pre-buffer. Everything worked fine. Then I upgraded my firmware (061009 DL1 customer reflash.zip). Now, whenever I plug in my DL1, it starts logging data. If I press the red button, it stops logging. But ...

I have a DL1 with firmware version 3.2. I know version 4.2 is out (my friend has a DL1, too). Is there any way to upgrade the firmware?