Search found 5 matches

by sirandrewbutler
Mon Oct 10, 2022 7:36 am
Forum: General software support
Topic: Video4 footage in Analysis V10
Replies: 0
Views: 103914

Video4 footage in Analysis V10

I've been trying to import video files from my Video4 into Analysis V10 in the same way as you would import a file from a GoPro. Unfortunately it doesn't seem to work and Analysis hangs up consuming quite a lot of CPU and RAM (according to Windows Task Manager). Is there a way to make this work? If ...
by sirandrewbutler
Wed Apr 14, 2021 9:03 pm
Forum: General support questions
Topic: losing RPM signal sometimes
Replies: 4
Views: 27466

Re: losing RPM signal sometimes

I’ve put a scope on the tacho output from the OMEX. It’s a 0v-battery voltage square wave 50% duty cycle with two pulses per revolution. This sounds ideal to drive the low RPM input on the DL1 but that doesn’t seem to work. Does the RPM earth need to be removed from the DL1 when going from the high ...
by sirandrewbutler
Mon Apr 12, 2021 8:41 pm
Forum: General support questions
Topic: losing RPM signal sometimes
Replies: 4
Views: 27466

Re: losing RPM signal sometimes

Ok... The tacho wire i used from the old Pi systems loom comes directly from the tachometer out pin in the Omex 600 ecu. I would have thought this would drive the DL1 low input but I tried that and got 0 RPM on the dash with the engine running. I’m thinking a pull up may be required. Any help much a...
by sirandrewbutler
Mon Apr 12, 2021 3:25 pm
Forum: General support questions
Topic: losing RPM signal sometimes
Replies: 4
Views: 27466

Re: losing RPM signal sometimes

Hi Yes, the vehicle is fuel injected but Id rather not mess about with the loom as its quite nicely built. I'll trace the rpm feed and if it comes from a low source which will be free of transients I'll connect to the Low RPM input and see if that improves things. I've tested some more since my firs...
by sirandrewbutler
Thu Apr 08, 2021 2:08 pm
Forum: General support questions
Topic: losing RPM signal sometimes
Replies: 4
Views: 27466

losing RPM signal sometimes

Over winter I replaced an old Pi Systems data logger and dash in my car with a DL1 Club & Dash4. I picked up all the sensor inputs from the Pi loom including REVs which I have connected to the the high level input on the DL1 because I don't have a wiring diagram and am unsure of the origin of the si...

Go to advanced search